Few protrusions on the pistol could catch on a pocket holster, a deep concealment, or inside of waistband holster. All edges were rounded and smoothed allowing comfort while carrying concealed. The gun easily fit into a pocket, small holster, or inside a handbag. The barrel was near the minimum length possible with a Browning tilting-barrel system of operation. It was marketed to users who wanted a concealable firearm with a "full-power" defensive cartridge. It was only slightly wider than the staggered-column magazine it used. The P-11 was designed for concealed carry by members of the general public and law enforcement officers. The resulting PF-9 pistol weighs about the same loaded as the P-11 empty and is somewhat slimmer. In 2006, Kel-Tec introduced a single-stack pistol based on the P-11 with engineering improvements borrowed from the P-3AT. Kel-Tec has suspended production of these pistols and conversion kits. These models mated a P-11's frame to a larger slide width and barrel. These weapons were designated P-40 and P-357. ![]() ( December 2012) ( Learn how and when to remove this template message)įor a short period, the P-11 was offered in. Unsourced material may be challenged and removed. Please help improve this article by adding citations to reliable sources. ![]() This section needs additional citations for verification. Accessories such as trigger shoes, finger-rests, belt clips, steel guide rods to replace the factory installed polymer guide rod, gray- and OD green-colored polymer grip housings, night sights, and other accessories are also available from the manufacturer. The PF-9 has a single stack magazine holding 7 rounds. It has been developed from the highly successful P-11 and P-3AT pistols with maximum concealability in mind. The PF-9 is a semi-automatic, locked breech pistol, chambered for the 9mm Luger cartridge. KEL TEC P 11 TRIGGER SERIESSmith & Wesson series 69 compact 12-round magazines would also work, with a matching short adapter sleeve, as well. Kel-Tec PF-9 9mm Centerfire Carry Conceal Pistol. An adapter was available that would wrap around the base of 15-round Smith & Wesson model 59-style magazines. ![]() The P-11 would also accept some Smith & Wesson 59 series magazines. A firing pin spring and low-mass hammer prevented discharge if the gun was dropped. KEL TEC P 11 TRIGGER MANUALThe P-11 lacked an external manual safety, relying instead on a long and heavy double action only trigger pull, which requires 9 pounds of pressure, to prevent accidental discharge. At 17.1 oz (480 g) unloaded, the handgun itself was comparatively light. The slide, barrel, and magazine were steel. The P-11 used an aluminum receiver inside a polymer grip housing held on with polymer pins. The P-11 was designed by Swedish-born George Kellgren, the designer of many earlier Husqvarna (Sweden), Intratec, and Grendel brand firearms.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |